Therm pro timer pt04 instructions manual#

The power button, press the power button again and you should get 3 blinks. Note 2: If you only get 1 blink from the remote sensor the first time you press You may have to repeat the pairing process.

Therm pro timer pt04 instructions manual#

This manual is available in the following languages: English. This manual comes under the category Coffee makers and has been rated by 1 people with an average of a 8.6.

Into the indoor unit and you haven't put the batteries into the remote sensor View the manual for the Melitta Look IV Therm Timer here, for free. To set a range of temperature for your oven or smoker, select 'Ambient Temperature' then slide the 'High' and 'Low' temperature lines to where you want them: 4. Select a type of meat then select how you would like it cooked: 3. Length: 4' (10cm), diameter: 0.16' (4mm), tip: 0.10' (2. Note: If more than 3 minutes have elapsed from the time you put the batteries On the apps main screen tap the 'Meat' button for the probe you would like to use. Up Arrow/HR Button: Press the up arrow to select food types while in quick temperature setting. When the countdown timer hits 0:00 press the S/S button to silence the unit. Press the S/S button to pause or restart the timer. The remote sensor should blink once this time and connect with the display unit. Press and hold the CF/ON/OFF button on the thermometer transmitter for 3 seconds to switch temperature units. Press the S/S button when in timer mode to begin the count-down timer. Then, you'll have 3 minutes to turn the sensor back on by pressing the power button for 2 seconds again.

Once this is done, you can put the batteries into the indoor unit. Press and hold for 2 seconds, the temperature value will decrease at a faster pace. In thermometer mode (Probe or 2), press once to decrease the 1 temperature value. Touch Sensitive BacklightOur kitchen timer features a touch backlight button located on the top of the timer, making it easier to adjust settings with the conveniently placed buttons or check. Press and hold for 2 seconds, the hours, minutes, or seconds will increase at a faster pace. With both units side by side, take the batteries out of the display unit and press the power button on the back of the remote sensor for 2 seconds until the indicator light, located on the front side of the remote sensor, blinks 3 times. In timer mode, press once to increase the Hour, Minute, or Second setting. If you can't see the OUT reading on your display unit, you may need to pair or re-sync your device with the remote sensor.